Simulations using ADE (G)XL

Setups for proper usage of ADE XL for NCSU CDK

; To run adexl properly for NCSU PDK
adexl.icrpStartup  binaryName string "virtuoso -nocdsinit"

First you need to create a test using the config view because Test using schematic view can be only used for schematic simulation. It is highly recommended to create a test using config view, which can be conveniently used for both schematic and postlayout simulation. The procedure is the same as a new schematic creation procedure except that the view needs to be config as shown below.

In the New Configuration windows that opens, shown on the right side of the above image. For the template, we want to use spectre by clicking on Use Template and choosing spectre. Then set your top cell accordingly.
Now that we have our test setup, we will create a new ADE (G)XL by going to Launch--> ADE XL in your config test windows. You will have the choice to create a new view or open and existing view. Here we will just use the default as shown below.

In the Create new ADE(G)XL view dialog box that opened change the view type to adexl and make sure that Cell corresponds to your design top level test bench as shown above.
Now you should have setup as shown below. Here it is important to make sure that the of your top level or any lower hierarchy is set to schematic when you want to run a schematic simulation or av_extracted in case you want to run a layout extracted view of that particular level. Also look at the environment under setup in your ADE windows to make sure that the view you intended to simulate is displayed first in the Parameter Range Checking File box. Otherwise you may be misled in your simulation which can be costly.

Option 1
- Double click the parameter value
- Click the button on the right of the value
- Run simulation

Option 2
- Setup the parameter sweep in ADE L
- Save the setup to an .il file
- Load the saved .il file into ADE (G)XL parameter setup
- Run simulation

Select Launch tab in the schematic.
- Select ADE XL.
- Select Create New View and then OK.

Once you have created a new ADE XL window view, go to the Data View window and select Tests.
- Clcik Add Test.
- Setup the tests, model files, variables and outputs in the ADE L window.
- Added tests (etc.) should appear under Tests in Data View window.
In the Data View window, select Corners.
- Click Add Corner.
- Click Add Model File.
  - Click Import from Test.
  - Add other model files if needed.
- Click Add new corner.
  - Click section and set the desired corner for the model files.
  - Rename the added test to match corner simulation (Optional).
- Repeat the above for all corner tests.
- Click OK.
- Added corners should appear under Corners in Data View window.

Note: You need to select the models that you are going to use by checking the corresponding box in the column of the corner.

Run the simulation.
To plot the results:
- Right click on graph symbol corresponding to the parameter you wish to plot.
- Select Plot Across Corners.

MonteCarlo Simulations using ADE XL - Monte Carlo simulations using ADE XL in Cadence

DRC
- For the purpose of this tutorial, we will use a simple inverter schematic and layout.
- So the first thing is to design your circuit and the corresponding layout.
- On the layout we want to make sure that no design rules are violated by using the DRC(Design Rules Checker) tool of the PDK.
- On the layout windows, go to IBM_PDK --> Checking --> Assura --> DRC as shown below.

Create a test in ADE (G)XL using schematicview
Setup the simulation configurations (or, you can setup the simulation configurations for schematic view in ADE L and save the state. Load the saved state).
Setup the extract view: parasitics>setup>choose the cell to setup its schematic, estimated, an extracted view
Run the simulation
- No parasitic: schematic simulation
- Extracted: postlayout simulation