Simulations using ADE (G)XL
Simulations using ADE (G)XL
- Create a ADE (G)XL
- Create a Test using schematic view (Schematic view can be only used for schematic simulation. It is highly recommended to create a test using config view, which can be conveniently used for both schematic and postlayout simulation).
Parameter sweeping
- Create a parameter sweeping in ADE L
- Save the setup to an .il file
- Load the parameter sweeping setup in ADE (G)XL
- Run the simulation
Corner Simulations using ADE XL
Postlayout simulation
- Create a config view
- Create a test in ADE (G)XL using config view
- Setup the simulation configurations (or, you can setup the simulation configurations for config view in ADE L and save the state. Load the saved state).
- Setup the extract view: parasitics>setup>choose the cell to setup its schematic, estimated, an extracted view
- Run the simulation
- No parasitic: schematic simulation
- Extracted: postlayout simulation
(under construction)